| General information of replacing a roller banner on | | | | sided tape onto the introducing film again. |
| the stand. | | | | Step four - Take off the top bar from old banner |
| A roller banner is also called a roll up banner, pull | | | | then install the top bar onto the new banner you |
| up banner, or a pop up banner. Some clients | | | | wish to replace it. |
| found it is a big waste that the display stands only | | | | Step five - Attached the new banner onto the |
| be used several times or for a very short period. | | | | introducing film. Then pull the pin out of the base |
| It is a good idea that keep the banner stands and | | | | (while holding the graphic to avoid it bouncing back |
| buy a new replacement banner. Replacing the | | | | to fast). Done! You have successfully replaced a |
| graphic is a simple process. It is saving money and | | | | banner onto the roller stand. |
| helping our environment. | | | | How much am I supposed to pay for buying a |
| Step one - Pull the banner out from the base to | | | | replacement banner? The price listed below is my |
| the end. You will find the banner is attached on a | | | | research of buying a replacement banner from |
| piece of introducing film. Usually these two parts | | | | the roller banner UK market: |
| are jointed by double sided tape. | | | | Size: 85cm x 200cm |
| Step two - Find a pin at the bottom of the | | | | Stop light film with laminate: £50.00 - |
| banner stands. Inset the pin into the side of the | | | | £95.00 |
| base (while slightly releasing the graphic). The | | | | Stop light film without laminate: |
| spring inside the stand now is locked. | | | | £50.00-£75.00 |
| Step three - Trim the old banner off from the | | | | PP paper with laminate (not recommended): |
| introducing film then attached new the double | | | | £30.00-£55. |